Insta-cure Gap-Filling Glue 1.oz



Add to Cart:


$6.99

Insta-cure Gap-Filling Glue 1.oz

1oz

Perfect for all urethane resin model kits.  Also works great for filling gaps, pin holes.  Better than Hobby brands! read below. 
Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ ™ should also be used. To prevent premature curing, don’t spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out.

 

Show More




WARNING: Monsters In Motion sells products, including children's products, for purchase by adults 18 years and over. Products may contain sharp points, small parts, choking hazards, and other elements not suitable for children under 16 years old. If any product you are purchasing is intended for a child please assume the following warning may apply to that product. WARNING: CHOKING HAZARD -- Small parts. Not for children under 3 yrs.


Your IP Address is: 3.148.105.127
wabusiness template