Insta-Cure Gap-Filling Glue 2oz

Insta-Cure Plus Gap Filling 2 Ounce Cyanoacrylate Glue:

 Perfect for all urethane resin model kits.  Also works great for filling gaps, pin holes.  Better than Hobby brands! read below. 

Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ ™ should also be used. To prevent premature curing, don’t spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out.

Works Best On:

Balsa Wood

Soft Wood

Works Good On:

Hard Wood

Glass & Metal

Fiberglass

Ceramics

Hard Plastics

Rubber

Laminating

Water-Resistant

Reinforcing

Instacure Gap-Filling Glue 2oz, bob smith, Glue, cyano